The Magnetic Separator is used for separating crude mineral by different magnetic rigidities. The customers often encounter problems in the use process. We summarize the common failures and solution about magnetic separation machine:

1. The motor overheating and abnormal of magnetic separator:

1) The lubrication of bearing is bad or wear is very serious;

2) The fan leaves fall off or wear;

3) The line contact of switch is undesirable, or break line and run single-phase;

4) The voltage is too low.

2. The sound of magnetic separator is normal in the running, cylinder gets stuck by the barrier, and even cylinder can not turn, the bottom cases is trembling. Its reason is often that the bottom cases gets stuck by object, or magnet falls off, and make the cylinder body creaky, the serious is that the tube skin is scratched. At this time, we should stop to maintain and remove the faults.

3. The reducer overheating reasons:

1) The oil is not enough or oil quality is bad;

2) The worm and gear seriously is worn; meshing is bad;

3) The bad bearing lubrication or severe worn.

4. The magnetic field intensity become weak:

1) The temperature is too high;

2) The sunlight exposure;

3) The acid and alkali corrosion.

Pre: The Structure and Working Principle of the Spiral Classifier

Next: How to Add Water during the Processing of Spiral Chute